Matters needing attention when using the blister machine


Release time:

2023-08-11

1. The power supply must be cut off when the hand reaches under the guide rail for operation, and there can be no accident of turning on the power supply. 2. When the machine uses the secondary upper mold function, please do not put your hand into the molding area to touch the product being cooled, so as to prevent the hand from being crushed when the second upper mold comes down. 3. In the heating area, please do not touch the heating device and baked goods with your hand, when the product length is less than 800mm, the upper gate and the upper die must be synchronized. When the local machine is adjusted, the upper brake should be opened first, and then the upper mold should be opened. 5. When the local machine is adjusted, if the solenoid valve is used to power on for debugging, attention should be paid to whether the power failure will cause damage. 6. When the material receiving piece is sent to the knife switch by hand and the slice position is adjusted, the knife switch should be closed. In the automatic state, hands should not be put into the knife switch cabinet.

1. The power supply must be cut off when the hand reaches under the guide rail for operation, and there can be no accidental power-on situation

2. When the machine uses the secondary upper mold function, please do not put your hand into the molding area to touch the product being cooled, so as to prevent the hand from being crushed when the second upper mold comes down

3. In the heating area, please do not touch the heating device and bake goods with your hand, when shutting down, the heating furnace should be raised

4. When the product length is less than 800mm, the upper gate and the upper die must be synchronized. When the local machine is adjusted, the upper brake should be opened first, and then the upper mold

5. When the local machine is adjusted, if the solenoid valve is energized for debugging, attention should be paid to whether the power failure will cause damage

6. When the material receiving piece is fed into the knife switch by hand and the slice position is adjusted, the knife switch should be closed, and the hand should not be extended into the knife switch cabinet in the automatic state.

Key words:

Spot welding machine series


online message

%{tishi_zhanwei}%

Contact Us

Address: Factory Building ,No. 9, 3293 Hongmei South Road, Minhang District, Shanghai

Zip Code: 201108

Tel: 021-66613330 021-66613320

Fax: 021-56558970

Mobile Phone: 13901833321 13585855550

Mailbox: hongdu@vip.sina.com